Bay Networks Nautica 200 Reference Manual page 64

NauticaRS Release 4.1 Reference Guide
bcc> %taprog% 1
c:> isdnprog filename
2-6
c. Follow the prompts on the screen to load the new code.
The file to load is CLAM.BAY and is located in the
default Nautica Wizard directory (usually Program
Files/Bay Networks/Nautica Wizard).
8. Load new ISDN module code
If your Marlin has been working with no errors, then there is
no need to upgrade to the new ISDN module code. If you
have been experiencing problems, or are preparing a unit for
installation at a customer site, it is recommended that you
upgrade to the new ISDN code.
With the Marlin running the new router code, connect to the
Manager port using the adaptor and cable provided, and issue
the following command from the BCC prompt to put the
ISDN module into bootmode:
Where 1 is the first BRI module.
Execute the following command from the DOS prompt:
Where
filename
Warning: If the ISDNPROG fails for any reason, do not power
off or reboot the Clam, instead run the ISDNPROG command
again.
9. Restore the unit's configuration
There are two ways to restore the configuration to the unit:
• Using Nautica Wizard: From Nautica Wizard, select
the target unit by clicking on the Clam icon in the main
window. Select File > Restore Router Configuration
from File.
is the name of the ISDN firmware.
117237-C Rev. A