Using Quick Setup - Bay Networks Nautica 200 Reference Manual

NauticaRS Release 4.1 Reference Guide

Using Quick Setup

bcc> setup
3-14
BCC comes with a Quick Setup option that guides you through
the basic steps needed to set up your router.
Caution: It is recommended that the ISDN line is connected
before setup is run as setup will place the first call automatically
when it closes.
Access the Manager Port via a Telnet or Hyperterminal session.
Once you are at the
Note: Quick Setup can be run at any time and any prompt. To
re-configure the router totally, you must set the unit back to its
default configuration. This is done by using the
(page 17-11). Type
reboot the unit. The unit will reset with all attributes set back to
the manufacturer's defaults.
The Quick Setup Routine is a list of questions which you must
answer to complete the setup.
Caution: Once you have started setup, there is no way to stop
it. You will have to answer through to the end. If this happens,
and you don't want to set the unit up, reboot the unit using the
verb (page 17-24), before saving. The Quick Setup
reboot
changes are removed.
Setup is used to set the router up for standard use with PPP,
cul-de-sac routing and also IPX routing IPX. Click on the option
below to go to the section of the setup procedure you require:
Standard Routing
Cul-de-sac Routing
IPX Routing
prompt, type:
bcc>
DEFCON at any prompt and answer Yes to
verb
DEFCON
117237-C Rev. A