Bay Networks Nautica 200 Reference Manual page 410

NauticaRS Release 4.1 Reference Guide
Verb:
MTC:
Options:
Function:
Instructions:
Example:
CALL 01296123456
CALL WAT3
17-6
Once the bootmode verb is executed, the unit is ready to receive
new software. The easiest way to download new software to the
unit is to use Nautica Wizard. Refer to the Nautica Wizard
documentation on the CD accompanying the unit for information
on how to download software.
Note: After the new software has been loaded, the unit should
be defconed (page
Call
call
call <num>|<pathname>
CALL allows a manual call to be placed directly to a
number or to a path already set up in the path level of
BCC.
If you type the CALL verb with a number, the Nautica
unit will attempt to make a Nautica call to the remote
unit on those routers that support the protocol. If the
Nautica protocol is not supported (i.e. on the Nautica
200) a PPP call will be made.
If the CALL verb is used with a pathname, the call will
be of the type specified by the path.
The following two examples show how to call a number
directly and to also place a call along a predefined path:
Several modifiers can be used with the number entered
after the call verb. These are explained on page 4-15.
17-11) and the configuration reloaded.
117237-C Rev. A