Device Statistics - Bay Networks Nautica 200 Reference Manual

NauticaRS Release 4.1 Reference Guide

Device Statistics

box# sh dev st eth/LAN01
Name
MAC Address
Rx Errors
Rx Bytes
Rx Frames
Rx Utilization :5
Rx Broadcasts :345
Rx Multicasts :352
Tx Errors
Tx Bytes
Tx Frames
Tx Utilization :6
Tx Broadcasts :168
Tx Multicasts :168
7-60
The activity of a device can be displayed on the screen. From any
configuration prompt use the following syntax (begin the
command line with
SH DEV ST TYPE/NAME
where
SH DEV ST
is the type of device and
shown when
LSO -L
To display the information on a LAN port, the following would
be typed:
The information as shown here will appear on the screen:
:LAN01
:002062020327
:0
:23355745
:23161
:0
:3764024
:13054
The port statistics display a cumulative count for each defined
parameter since the statistics were last cleared or the unit was
reset. The transmit and receive utilization is not cumulative but is
updated in real time. Tx (transmit) and Rx (receive) multicasts
and broadcasts refer to the MAC layer and only apply to LAN
ports.
if you are at the
CO
tells BCC to display
is the name of the device (as
NAME
is typed at the
box#
prompt):
BCC>
statistics,
DEVice
prompt).
117237-C Rev. A
TYPE