Parameter:
MTC:
Default:
Options:
Function:
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
117237-C Rev. A
State
st
enabled
enabled, disabled
The default here is Enabled, set to Disabled and the
Wan is no longer enabled.
Mode
mode
async
async
The operating mode of the device: Async.
Use Sync for establishing connections to other Nautica
or PPP routers via a leased circuit connection. If
attaching to a frame relay network, either directly or via
a leased circuit, FrameRelaySync must be selected.
Speed
sp
9600
A valid speed
The speed, in bits/second, of the interface.
Changing this parameter does not change the actual
device speed, which is determined by the attached DCE
clock rate. This parameter should be altered to allow the
correct device speed to be displayed in all the relevant
status screens.
Note:
to operate with the new settings, the device must be
powered off and on after changing the WAN device speed.
Controlling Router Devices
7-53