Bay Networks Nautica 200 Reference Manual page 107

box# new wi Remote_Server/group\
box# /static
[Save] wins/Remote_Server/group/static#
117237-C Rev. A
• If the commands you are typing to configure an object are
too long to fit on one line, typing [
cursor to the next line of the command without executing any
commands typed so far. Pressing [
action all lines of a command.
In this example, the information needed to enter a new WIns
is too long to fit on one line. the [
wrap to the next line without the command being run. When
enter is pressed without the [
command is run and the unit moves into the new WIns.
• Where possible, use the MTCs for command names rather
than the full command.
• Exiting the Manager without quitting (due to a computer
crash perhaps) will not save changes or reboot the unit. When
you log into the unit again, you will be returned to the same
prompt you were at when the system exited early (unless you
are using TELNET; then you will have to log in again).
Changes will only be lost if the unit has been powered down
and up after exiting.
Understanding the Command Line
][
\ ENTER
] by itself will
ENTER
] allows the command to
\
] (after the
\ static
] will wrap the
attribute) the
3-29