Simple Configuration - Bay Networks Nautica 200 Reference Manual

Simple Configuration

box# sy
system#
box# mod pa ppp/remoteppp
box# mod dev voi/voice01
117237-C Rev. A
To move into configuration mode, type
The prompt will change to read
are in configuration mode.
In Figure 3-1 all the contexts under
move into a level, for example
the prompt:
Pressing [
ENTER
into the level of the unit, the prompt changes to reflect
SYstem
this:
To move back to the
Context) at any prompt. For more information on movement
commands, refer to
The DEVice and PAth contexts cannot be accessed by
themselves, you must also enter the type and name of the PAth or
DEVice that you wish to modify or create.
To list all the PAths and DEVices, at the
. When you can see the object you wish to modify, use the
-l
following syntax:
mod pa type/name
mod dev type/name
For example:
allows you to modify the settings of a path called RemotePPP.
allows you to modify the Voice01 device.
Understanding the Command Line
box # .
SYstem
] at the end of this command line will move you
prompt, type
box#
page 3-10.
at the
CO bcc>
The # sign shows that you
can be configured. To
box#
, type its name or MTC at
(Change Working
cwc
prompt, type
box#
prompt.
LSO
3-9