How Do I Install The Virtual Packet Driver In Windows 95 - Bay Networks Nautica 200 Reference Manual
Nortel nautica 200: reference guide
Hide thumbs
Also See for Nautica 200:
- Reference manual (642 pages) ,
- Release note (38 pages) ,
- Installation manual (23 pages)
Table of Contents
Advertisement
How Do I Install the Virtual Packet Driver in Windows
95?
[ndis3pkt]
netcard=0
intvec0=0x66
117237-C Rev. A
The Virtual Packet Driver installs as a plug-and-play protocol
from the network section of the Windows Control Panel. As the
final part of the installation process, you can customize the
Virtual Packet Driver's settings so that it uses the default software
interrupt also used by the Nautica software load programs. The
installation process is as follows:
1.
Take the packet driver installation files NDIS3PKT.386 and
NDIS3PKT.INF and copy them to diskette or place them in
their own directory on your PC.
2.
From the network section of the Control Panel, click the
button to add a new network protocol.
3.
When prompted for the manufacturer of the protocol, click
on 'Have Disk', and direct the install program to the disk or
directory created in Step 2. Click on OK once the Virtual
Packet Driver is highlighted. The install program builds the
driver information database.
4.
After the driver is installed, click on OK to exit the network
configuration.
5.
Answer No when prompted to restart Windows 95.
6.
From the Start Menu, select run and enter SYSEDIT to run
the system configuration utility. Select the window for
SYSTEM.INI and move to the bottom of the file.
7.
At the bottom of the file, the following section was added
during the installation of the driver:
8.
Add a line after this that reads as follows:
9.
Save the edits to the SYSTEM.INI file, close SYSEDIT and
restart Windows for the changes to take effect.
Upgrading Router Software
2-17
Advertisement
Table of Contents
