INVT Goodrive 310-UL Series Operation Manual page 73

GD310-UL series VFD
Function
Name
code
the input
terminals
ON-OFF filter
P05.11
time
Virtual
P05.12 terminals
setting
Terminals
P05.13 control running
mode
Set the bit to 0, the input terminal is anode.
Set the bit to 1, the input terminal is cathode.
BIT0 BIT1
S1 S2
BIT5 BIT6
S6 S7
The setting range: 0x000–0x1FF
Set the sample filter time of S1–S8 and HDI
terminals. If the interference is strong, increase the
parameter to avoid the disoperation.
0.000–1.000s
0x000–0x1FF (0: Disabled, 1: Enabled )
BIT0: S1 virtual terminal
BIT1: S2 virtual terminal
BIT2: S3 virtual terminal
BIT3: S4 virtual terminal
BIT4: S5 virtual terminal
BIT5: S6 virtual terminal
BIT6: S7 virtual terminal
BIT7: S8 virtual terminal
BIT8: HDI virtual terminal
Set the operation mode of the terminals control
0: 2-wire control 1, comply the enable with the
direction. This mode is widely used. It determines the
rotation direction by the defined FWD and REV
terminals command.
FWD
K1
REV
K2
COM
1: 2-wire control 2; Separate the enable from the
direction. FWD defined by this mode is the enabling
ones. The direction depends on the state of the
defined REV.
Description
BIT2 BIT3
S3 S4
BIT7 BIT8
S8 HDI
Running
FWD REV
command
OFF OFF
ON OFF
running
OFF ON
ON ON
-65-
Function parameter
Default
value
BIT4
S5
0.010s
0x000
Stop
0
FWD
REV
running
Hold
Modify
○
◎
◎