Simple Plc - INVT Goodrive350 Series Operation Manual

Goodrive350 series high-performance multifunction VFD
Function
code
Output terminal polarity
P06.05
Y switch-on delay
P06.06
Y switch-off delay
P06.07
HDO switch-on delay
P06.08
HDO switch-off delay
P06.09
Relay RO1 switch-on
P06.10
Relay RO1 switch-off
P06.11
Relay RO2 switch-on
P06.12
Relay RO2 switch-off
P06.13
Output terminal status at
P07.40
Digital output terminal
P17.13

5.5.13 Simple PLC

Simple PLC is a multi-step speed generator, and the VFD can change the running frequency and
direction automatically based on the running time to fulfill process requirements. Previously, such
function was realized with external PLC, while now, the VFD itself can achieve this function.
The VFD can realize 16-step speeds control, and provide four groups of acceleration/deceleration
time for choose.
After the configured PLC completes a cycle (or stage), an ON signal can be output by the
multi-function relay.
P10.00（simple PLC mode）
Stop after running
0
once
1 Keep running in the
final value after
running once
2
Cyclic running
PLC mode
Name
selection
delay
delay
delay
delay
present fault
state
Power cut during
running
Setup of running
parameters of each
PLC stage
Description
57–63: Reserved
0x00–0x0F
0.000–50.000s
0.000–50.000s
0.000–50.000s (valid only when P06.00=1)
0.000–50.000s (valid only when P06.00=1)
0.000–50.000s
0.000–50.000s
0.000–50.000s
0.000–50.000s
/
/
P10.01 (simple PLC memory selection)
0
No memory
after power off
1
Memory after
power off
Normal running
P10.36
(PLC restart mode)
-109-
Basic operation guidelines
Restart running
0
after the first
section
0
1 Continue running at
1
the frequency when
interruption occurred
Terminal function 23
Simple PLC stop reset
Default
value
0x00
0.000s
0.000s
0.000s
0.000s
0.000s
0.000s
0.000s
0.000s
0x0000
0x00
Set frequency
P17.00