INVT Goodrive350 Series Operation Manual page 197

Goodrive350 series high-performance multifunction VFD
Function
Name
code
P08.27 Set running time 0–65535min
Automatic fault
P08.28
reset times
Automatic fault
P08.29 reset time
interval
Reduction ratio of
P08.30
droop control
Switchover
selection for
P08.31
motor 1 and
motor 2
FDT1 level
P08.32
detection value
FDT1 lag
P08.33
detection value
FDT2 level
P08.34
detection value
P08.35 FDT2 lag
Description
Automatic fault reset times: When the VFD selects
automatic fault reset, it is used to set the times of
automatic reset, if the continuous reset times
exceeds the value set by P08.29, the VFD will
report fault and stop to wait for repair.
Interval of automatic fault reset: select the interval
time from when fault occurred to automatic fault
reset actions.
After VFD starts, if no fault occurred during 60s,
the fault reset times will be zeroed out.
Setting range of P08.28: 0–10
Setting range of P08.29: 0.1–3600.0s
This parameter specifies the variation rate of the
VFD output frequency based on the load; it is
mainly used in balancing the power when multiple
motors drive the same load.
Setting range: 0.00–50.00Hz
0x00–0x14
Ones: Switchover channel
0: Terminal
1: Modbus/Modbus TCP communication
2: PROFIBUS/CANopen/DeviceNet
communication
3: Ethernet communication
4: EtherCAT/PROFINET/EtherNet IP
communication
Tens: indicates whether to enable switchover
during running
0: Disable
1: Enable
When the output frequency exceeds the
corresponding frequency of FDT level,
multi-function digital output terminal outputs
"frequency level detection FDT" signal, this signal
will be valid until the output frequency lowers to
below the corresponding frequency (FDT
level-FDT lag detection value), the waveform is
shown in the figure below.
-188-
Function parameter list
Default
Modify
value
○
0min
○
0
○
1.0s
○
0.00Hz
◎
0x00
○
50.00Hz
○
5.0%
○
50.00Hz
○
5.0%