Table of Contents
Advertisement
Refitting the balancing device shaft
1
2
3
4
Restoring the balancing device
1
Product manual - IRB 6650S
3HAC020993-001 Revision: AG
Action
Lubricate the shaft with grease.
Fit the shaft to the piston shaft front eye
through the hole in the frame, using the press
equipment, balancing device shaft, according
to user instructions enclosed with the equip-
ment.
xx0900000813
Go to the user instructions enclosed with the
press tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
Refit the securing screw into the shaft using
locking liquid.
Lubricate the bearing in the ear with grease
through the lubricating nipple, with a grease
pump.
Fill until excessive grease pierces between the
shaft and the sealing spacer.
Action
Restore the balancing device according to in-
structions for the press equipment.
xx0900000813
Go to the user instructions enclosed with the
press tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
© Copyright 2004-2022 ABB. All rights reserved.
4.5.4.1 Replacing the balancing device
Note
Art. no. is specified in
equipment on page
Art. no. is specified in
equipment on page
User instructions are enclosed with
the tool.
Note
Make sure to keep the balancing
device unloaded.
Note
Make sure the shaft is pressed all
the way to the bottom.
M16 x 180, tightening torque: 120
Nm.
Locking liquid is specified in
quired equipment on page
Art. no. and amount are specified in
Required equipment on page
Lubrication is further detailed in
section
Lubrication of spherical roller
bearing, balancing device on
page
175.
Note
Art. no. is specified in
equipment on page
User instructions are enclosed with
the tool.
Continues on next page
4 Repair
Continued
Required
289!
Required
289!
Re-
289!
289!
Required
289!
297
Advertisement
Table of Contents
