Table of Contents
Advertisement
2
Restoring the balancing device
1
2
3
4
Product manual - IRB 6650S
3HAC020993-001 Revision: AG
Action
Pull the shaft out using the press equipment,
balancing device shaft, according to user in-
structions enclosed with the equipment.
xx0900000813
Go to the user instructions enclosed with the
press tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
Action
Restore the balancing device according to in-
structions for the press equipment.
xx0900000813
Go to the user instructions enclosed with the
press tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
Lubricate and refit the o-ring at the end of the
balancing device.
Make sure the damper is properly fitted to the
support shaft and refit them both to the balan-
cing device.
Lubricate and refit the o-ring on the support
shaft.
© Copyright 2004-2022 ABB. All rights reserved.
4.5.4.1 Replacing the balancing device
Note
Art. no. is specified in
equipment on page
User instructions are enclosed with
the tool.
Note
Make sure to keep the balancing
device unloaded.
Note
Art. no. is specified in
equipment on page
User instructions are enclosed with
the tool.
Make sure the o-ring is seated prop-
erly! Replace if damaged.
Make sure the o-ring is seated prop-
erly! Replace if damaged.
Continues on next page
4 Repair
Continued
Required
289!
Required
289!
293
Advertisement
Table of Contents
