Table of Contents
Advertisement
Draining, oil, axis 6
The procedure below details how to drain oil from the gearbox, axis 6.
When using the oil exchange equipment, follow the instructions enclosed with the
kit. Art. no. for the kit is specified in
1
2
3
4
5
Filling, oil, axis 6
The procedure below details how to fill oil into the gearbox, axis 6.
When using the oil exchange equipment, follow the instructions enclosed with the
kit. Art. no. for the kit is specified in
1
2
3
Product manual - IRB 6650S
3HAC020993-001 Revision: AG
Action
Run the robot to a position where the oil plug,
filling of axis 6 gearbox is facing downwards.
DANGER
Turn off all:
•
electric power supply to the robot
•
hydraulic pressure supply to the robot
•
air pressure supply to the robot
Before entering the robot working area.
WARNING
Handling gearbox oil involves several safety risks,
see
Gearbox lubricants (oil or grease) on page
Drain the oil from the gearbox into a vessel by
removing the oil plug.
Measure the amount of oil drained.
Refit the oil plug, draining.
Action
DANGER
Turn off all:
•
electric power supply to the robot
•
hydraulic pressure supply to the robot
•
air pressure supply to the robot
Before entering the robot working area.
WARNING
Handling gearbox oil involves several safety risks,
see
Gearbox lubricants (oil or grease) on page
Remove the oil plug, filling.
© Copyright 2004-2022 ABB. All rights reserved.
3.4.7 Changing oil, axis-6 gearbox
Required equipment on page
Note
Shown in the figure
gearbox on page
36.
Vessel capacity is specified in
quired equipment on page
The amount of oil to be refilled de-
pends on the amount previously
drained.
Tightening torque: 24 Nm.
Required equipment on page
Note
36.
Shown in the figure
gearbox on page
Continues on next page
3 Maintenance
Continued
168.
Location of
168.
Re-
168.
168.
Location of
168.
169
Advertisement
Table of Contents
