Table of Contents
Advertisement
Refitting, turning disk
Use this procedure to refit the turning disk.
1
2
3
4
5
6
Product manual - IRB 6650S
3HAC020993-001 Revision: AG
Action
Lubricate the o-ring of the turning disk with
grease and fit it to the turning disk.
Also fit the 12 o-rings, when refitting the attach-
ment screws.
Foundry Plus:
Apply Loctite 574 flange sealant on the contact
surface.
Secure the turning disk with its attachment
screws.
Perform a leak-down test of the gearbox axis
6.
Refill the axis 6 gearbox with oil.
Refit any equipment removed during disas-
sembly to the turning disk.
© Copyright 2004-2022 ABB. All rights reserved.
4.4.1 Replacing the turning disk
Note
Art. no. is specified in
Required equip-
ment on page
237.
xx0200000218
•
A: Sealing surface, o-ring
xx1400000995
12 pcs, M12 x 30, 12.9 quality Gleitmo.
Tightening torque: 100 Nm.
Reused screws may be used, providing
they are lubricated as detailed in sec-
tion
Screw joints on page 411
ting.
Detailed in the section
Performing a
leak-down test on page
190.
See section
•
Changing oil, axis-6 gearbox on
page 168
Continues on next page
4 Repair
Continued
before fit-
239
Advertisement
Table of Contents
