Set Sinking Mode/Sourcing Mode; Set Input Signals For Mfai Terminals A1 To A3 - YASKAWA GA700 Technical Manual

2.15 Control I/O Connections
◆

Set Sinking Mode/Sourcing Mode

Close the circuit between terminals SC-SP and SC-SN to set the sinking mode/sourcing mode and the internal/
external power supply for the MFDI terminals. The default setting for the drive is internal power supply sinking
mode.
NOTICE: Do not close the circuit between terminals SP and SN. Failure to obey will cause damage to the drive.
Mode Internal Power Supply (Terminal SN-SP)
Sinking Mode
(NPN)
Sourcing Mode
(PNP)
◆

Set Input Signals for MFAI Terminals A1 to A3

Use terminals A1 to A3 to input a voltage or a current signal. Set the signal type as shown in
DIP Switch Settings
Termi Input
nal Signal
Switch
Voltage
input
A1 S1-1
Current
input
Voltage
input
A2 S1-2
Current
input
114
Figure 2.114 Location of DIP Switch S1
Table 2.28 MFAI Terminals A1 to A3 Signal Settings
Setting No.
V 0: 0 V to 10 V/0% to 100% (input impedance: 20 kΩ)
(Default) 1: -10 V to +10 V/-100% to 100%
H3-01
2: 4 mA to 20 mA/0% to 100%
I
3: 0 mA to 20 mA/0% to 100% (input impedance: 250 Ω)
0: 0 V to 10 V/0% to 100% (input impedance: 20 kΩ)
V
1: -10 V to +10 V/-100% to 100%
H3-09
I 2: 4 mA to 20 mA/0% to 100%
(Defaul) 3: 0 mA to 20 mA/0% to 100% (input impedance: 250 Ω)
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
External Power 24 V
Table
Parameters
Signal Level
2.28.