YASKAWA GA700 Technical Manual page 435

5.
Check the terminal sign that you wired and use a nipper as shown in
cutaway section of the wiring cover.
A - Cutaway sections
Note:
• Different drive models have different wiring cover shapes.
• Only clip the section of the wiring cover that applies to the wired terminal. If you clip areas that do not apply to wired
terminals, the protective enclosure will not keep its IP20 protective level.
• Be careful when clipping the cutaway section of the wiring cover, as the section may fly out in unpredictable directions.
• Make sure that the clipped section does not cause damage to the wires.
• If you use wires that are not specified by Yaskawa, the protective enclosure could lose its IP20 protective level, although the
wiring cover is correct. Contact Yaskawa or your nearest sales representative for more information.
6.
Put the wiring cover in its initial position. Put the cables through the holes that you cut out of the wiring
cover.
■
Connect the Control Circuit Terminal Block
1.
To put a wired control circuit terminal block in the drive, align it with the guides and move it straight up.
A - Guides
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
Figure 7.71 Clip the Cutaway Section of the Wiring Cover
Figure 7.72 Reattach the Wiring Cover
Figure 7.73 Put the Terminal Block into the Connector
Figure 7.71
B - Clip here with nippers
7.5 Replace the Drive
to clip the specified
435
7