YASKAWA GA700 Technical Manual page 221

4.1 General Safety
WARNING
Sudden Movement Hazard
Do not do work on the drive without eye protection. Wear eye protection before you start work
on the drive.
Failure to obey could cause serious injury or death.
Electrical Shock Hazard
Do not immediately energize the drive or operate peripheral devices after the drive blows a fuse
or trips an RCM/RCD. Wait for the time specified on the warning label at a minimum and make
sure that all indicators are OFF. Then check the wiring and peripheral device ratings to find the
cause of the problem. Contact Yaskawa before energizing the drive or peripheral devices if the
cause is not known.
Failure to obey can cause death or serious injury and damage to the drive.
NOTICE
Observe correct electrostatic discharge (ESD) procedures when touching the drive and circuit
boards.
Failure to obey can cause ESD damage to the drive circuitry.
Do not connect or disconnect the motor from the drive while the drive is supplying voltage.
Incorrect equipment sequencing can cause damage to the drive.
Do not use unshielded wire for control wiring. Use shielded twisted-pair wires and ground the
shield to the ground terminal of the drive.
Failure to comply may cause electrical interference resulting in poor system performance.
Do not allow unqualified personnel to use the product. Before you connect a dynamic braking
option to the drive, make sure that you review Braking Unit and Braking Resistor Unit
Installation Manual TOBPC72060001.
Failure to obey can cause damage to the drive and braking circuit.
Do not change the drive circuitry.
Failure to obey can cause damage to the drive and will void warranty. Yaskawa is not responsible for
modifications of the product made by the user.
Make sure that all connections are correct after you install the drive and connecting peripheral
devices.
Failure to obey can cause damage to the drive.
4
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 221