YASKAWA GA700 Technical Manual page 979

applicable before the alarm was turned off.
a decreased output frequency.
Figure 11.146 Drive Operation at a Decreased Output Frequency when the Overheat Alarm is Output
■
L8-05: Input Phase Loss Protection Sel
No.
Name
(Hex.)
L8-05 Input Phase Loss
Protection Sel
(04B1)
0 : Disabled
1 : Enabled
The drive measures ripples in DC bus voltage to detect input phase loss.
The drive detects phase loss when power supply phase loss occurs or the main circuit capacitor becomes unusable,
which causes PF [Input Phase Loss] to show on the keypad.
Disable the detection of the input power supply phase loss function in these conditions:
• During deceleration
• The run command is not input
• The output current is less than 30% of the drive rated current.
■
L8-07: Output Phase Loss Protection Sel
No.
Name
(Hex.)
L8-07 Output Phase Loss
Protection Sel
(04B3)
Note:
The drive can incorrectly start output phase loss detection in these conditions:
• The motor rated current is very small compared to the drive rating.
• The drive is operating a PM motor with a small load.
0 : Disabled
1 : Fault when one phase is lost
If the drive loses one output phase, it will trigger LF [Output Phase Loss].
The output turns off and the motor coasts to stop.
2 : Fault when two phases are lost
If the drive loses more than one output phase, it will trigger LF [Output Phase Loss].
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
Figure 11.146
V/f CL-V/f OLV CLV AOLV
Sets the function to enable and disable input phase loss detection.
V/f CL-V/f OLV CLV AOLV
Sets the function to enable and disable output phase loss detection. The
drive starts output phase loss detection when the output current decreases to
less than 5% of the drive rated current.
11.9 L: Protection Functions
shows the output of the alarm and the drive operation at
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Default
(Range)
1
(0, 1)
Default
(Range)
0
(0 - 2)
11
979