YASKAWA GA700 Technical Manual page 48

2.7 Install the Keypad to a Control Panel or Another Device
1.
Use the panel cut-out dimensions in
the keypad.
Figure 2.15 Panel Cut-Out Dimensions to Attach Inside Control Panel
W
64 + 0.5 (2.52 + 0.02)
2.
Remove the keypad and put the keypad connector in the holder on the front cover.
Note:
Insert the end of the keypad connector that has the tab.
A - Keypad
B - Keypad connector
3.
Use the screws supplied with the mounting bracket, and attach the keypad to the mounting bracket.
Tighten the screws to a tightening torque of 0.49 to 0.73 N∙m (4.34 to 6.46 lb.∙in.).
A - Keypad
B - Mounting bracket A
48
Figure 2.15 and
Table 2.10 Panel Cut-out Dimensions mm (in.)
H
130 (5.12) 45 (1.77)
C - Holder
Figure 2.16 Remove the Keypad
C - M3 screws
Figure 2.17 Attach Keypad to Mounting Bracket
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
Table 2.10 to cut an opening in the control panel for
W1 H1
105 + 0.5 (4.13 +
0.02)
d
4.8 (0.12)