YASKAWA GA700 Technical Manual page 46

2.7 Install the Keypad to a Control Panel or Another Device
■
Install Outside of Control Panel
1.
Use the panel cut-out dimensions in
the keypad.
Figure 2.11 Panel Cut-Out Dimensions to Attach Outside of Control Panel
W
22 (0.89)
2.
Remove the keypad and put the keypad connector in the holder on the front cover.
Note:
Insert the end of the keypad connector that has the tab.
A - Keypad
B - Keypad connector
3.
Put the keypad on the outside of the control panel.
Use M3 screws (6 mm (0.2 in.) depth cross-recessed pan head screws) to attach the keypad from the
inside. Tighten the screws to a tightening torque of 0.49 N∙m to 0.73 N∙m (4.34 lb.∙in. to 6.46 lb.∙in.).
46
Figure 2.11
Table 2.9 Panel Cut-out Dimensions mm (in.)
H W1
78 (3.07) 22 (0.89)
Figure 2.12 Remove the Keypad
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
and Table 2.9 to cut an opening in the control panel for
H1 H2
29 (1.14) 22 (0.89)
C - Holder
H3 d
1 (0.04) 3.6 (0.14)