YASKAWA GA700 Technical Manual page 163

4.
Push or
5.
Push or
6.
Push .
7.
Push or
When the U parameters are on the display as "Ux-xx", the three digits in "x-xx" identify which monitor to
output. For example, to show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
8.
Push or
9.
Push or
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
to select [Trend Plot], then push
to select [Custom Monitor 1], then push
to select the monitor number to register, then push
to select [Trend Plot 1 Scale Minimum Value], then push
to select the specified digit, then push
3.6 Keypad Operation
(Setup).
.
.
.
or to select the correct number.
3
163