YASKAWA GA700 Technical Manual page 182

3.6 Keypad Operation
4.
Push or
5.
Push or
Note:
This operation will initialize all parameters.
6.
Push or
7.
For the next steps, follow the instructions shown on the keypad until the "Parameter Change Confirmation
Screen" is shown.
8.
In the parameter change confirmation screen, push
select [Apply of each parameter] at the bottom of the screen and push
Note:
To change a parameter again, push
setting screen.
9.
Push or
The Setup Wizard procedure is complete.
182
to select [Setup Wizard], then push
to select [Yes], then push
to select the item to set, then push
or to select the parameter to change, then push
to select [Yes], then push
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
.
.
.
or to examine the changed parameter, then
.
.
to show the parameter