Table of Contents
Advertisement
CHAPTER 2: LOCAL MANAGEMENT
2.1 THE WAN PHYSICAL CONFIGURATION SCREEN
To access the WAN Physical Configuration screen from the Feature
Selection screen, use the arrow keys to highlight the WAN Configuration
option, then press ENTER. The screen shown in Figure 2-1 appears.
<host name> Local Management
WPIM 1
Type:
SY
BRIM #:
1
Mode:
[Primary]
Active:
Yes
Interfaces: 002
WPIM 1 Line Configuration
Sync Port Type:
Force CTS True:
Force DSR True:
SAVE
Figure 2-1. WAN Physical Configuration Screen
2.1.1 WAN Physical Configuration Screen Fields
The following sections describe WAN Physical Configuration screen
fields and instructions for setting them. The WAN Physical Configuration
screen lets you configure the WPIM or "Physical Interface."
Cabletron offers a variety of WPIMs. The following Physical
Configuration screen examples show the WPIM-SY and the WPIM-T1.
Select the WPIM you wish to configure by using the arrow keys to
highlight the WPIM command field at the bottom of the screen. Use the
SPACEBAR to select the appropriate WPIM, then press ENTER. The
WAN Configuration screen automatically displays unique configuration
fields for each WPIM as shown in Figure 2-1.
2-2
WAN PHYSICAL CONFIGURATION
WPIM 2
Type:
T1
BRIM #:
1
Mode:
[Secondary]
Active:
No
Interfaces: 003-026
[V.35]
[No]
[No]
[WPIM 1]
WAN INT CONFIG
WPIM-SY LOCAL MANAGEMENT GUIDE
Flash Image Version: xx.xx.xx
WPIM 1 Clock Configuration
Sync Clock Source:
Sync Tx Clock Speed:
Sync Rx Clock Speed:
RETURN
[External]
64000
64000
148301
Advertisement
Table of Contents
