Installing The 8U Rack Hardware - Qualstar XLS Series Installation Manual

7.1 Installing the 8U Rack Hardware

7.1 Installing the 8U Rack Hardware
This section describes how to install the mounting hardware for the 8U equipment rack.
The mounting hardware must be installed after the XLS is in its final location.
Important:
Required tools:
• #2 Phillips screwdriver
• 3/16-inch hex wrench
• 5/32-inch hex wrench
Required equipment:
8U equipment rack:
• 8U rack extension block
• Two brackets for the bottom of the rack
• Two brackets for the top of the rack
• Ten 6-32 × 3/8 Phillips screws
• Eight 1/4-20 × 5/8 socket-head cap screws (SHCS)
• Three 10-32 × 1/2 SHCS
7-2
With the hardware for the 8U equipment rack installed,
the XLS does not fit through a 36-inch door. Do not
install the mounting hardware for the 8U rack until
after the XLS is in its final location.
Obtain the following:
Make sure you have the following mounting hardware for the
501601 Rev. 07-01-19