Rack Mounting The Library; Figure 12 Install The Rack Rails; Required Tools - Qualstar Q48 Installation And Operation Manual

Q24/Q48 Tape Library
2.8

Rack mounting the library

NOTE
#3 Phillips screwdriver

Required tools:

T10 Torx screwdriver
•
•
1. Determine the location in which the library rack is to be installed.
Rack mounting the library:
2. Use a pencil to mark the location on each vertical rail in the rack.
3. In the rack mount kit are two sets of eight M6 screws. Determine the type of rack then choose
the appropriate type of M6 screws.
4. Secure one rail to each side of the rack in your chosen rack location with a #3 Phillips
screwdriver. Insure the rails are mounted level and at the same rack height on each side.
5. Secure both the front and back of each rack rail to the rack.
© Copyright QUALSTAR 2015
The rack rail components are optional accessories depending on

the ordered configuration. Skip this section, when the rack rail
components are not included.
Figure 13 Install the rack rails
Installation and Operations Manual
14