Qualstar XLS Series Installation Manual page 51

XLS-8161100 or XLS-832700
To remove the back and front shipping restraints, follow these steps:
1. Locate the two shipping restraints at the back. See
Figure 3-8 Location of the back shipping restraints
2. Using a 5/16-inch hex wrench (included in the accessory box), remove the
shipping restraints.
3. Open the doors on the front of the LRM.
4. Locate the two shipping restraints at the front.
the shipping restraint behind the right door; the shipping restraint on the left is
located behind the left door.
Figure 3-9 Location of a front shipping restraint (right side shown)
5. Remove the front shipping restraints.
6. Close the doors.
XLS Library Installation Manual
Shipping restraints
Shipping restraint
3
Unpacking the XLS
Figure 3-8.
Figure 3-9 shows the location of
3-9