Qualstar XLS Series Installation Manual page 180

11.5 Entering Configuration Information
up to eight HBA port numbers may be displayed.
numbers correspond to the ports' physical locations in the system controller.
HBA A
Figure 11-30 HBA port numbers (view from the back of the library)
5. In the Target Id drop-down list, select a new target ID for the HBA port.
6. Press Save HBA Target ID to save the information. The new target ID takes
effect as soon as the confirmation page appears.
Editing Tape Drive Target IDs
Within a drive bay, the default target IDs for the tape drives range from 4 to 1, which
match the physical addresses of the tape drive positions. See
Addresses."
To change the default target ID for a tape drive, follow these steps:
1. Access the Configuration portlet as described in
11-34
HBA B HBA C HBA D
Figure 11-30 shows how these
Appendix A, "Library
Section 11.5.1 on page
501601 Rev. 07-01-19
11-25.