Qualstar XLS Series Installation Manual page 104

7.3 Installing a Rack into the XLS-820500 or XLS-812300
1. Using a #2 Phillips screwdriver, attached either of the slide assemblies to the
right side of the frame using five of the 8-32 × 1/4 Phillips screws. See
Figure
Slide assembly
mounting holes (5)
Figure 7-11 Securing a slide assembly to rear of XLS-812300 (right side shown)
2. Attach the other slide assembly to the left side of the frame using the remaining
five 8-32 × 1/4 Phillips screws.
3. Pull both slide assemblies out of the frame until they are fully extended and
"lock" into position.
Do not install equipment into the rack before installing the rack into
the XLS. Otherwise, the rack may become too heavy to lift.
The rack will be easier to install with the help of an assistant.
4. With the help of an assistant position the empty rack so that the slide rails on the
side of the rack are aligned with the slide assemblies.
7-10
7-11.
CAUTION
Slide assembly
501601 Rev. 07-01-19