Qualstar XLS Series Installation Manual page 159

8. Using a 5/32" Allen wrench, remove the inner hard stop on the X-beam on the
side where the new expansion pod is installed. If two expansion pod's were
installed, remove both inner hard stops on the left and right side of the X-beam.
Figure 11-12 Outer and inner hard stops on the handler's X-axis (right side shown)
Never remove the outer hard stop or damage to the Library will occur.
9. Make sure the LRM door is open.
10. Power on the XLS Tape Library.
11. Login to the X-link Interface using the Administrator account and password.
XLS Library Installation Manual
11
Configuring the Physical Library
CAUTION
Inner hard stop
Outer hard stop
11-13