3.2.5
Roll the Unit into Position
After removing the four shipping restraints, you can roll the unit into position. Follow
these steps:
1.
Confirm that all of the levelling feet are fully retracted. See
Figure 3-14 Leveling foot in fully retracted position
2.
Carefully roll the unit down the ramps and to its intended location.
To avoid injury or equipment damage, use three or more people when
rolling the equipment to its final location.
3.
Unpack the tape drives, the equipment rack, and all accessory boxes.
4.
Remove the plastic sheets from the windows.
5.
Save the packing materials in case any of the equipment needs to be moved or
returned for service.
Be sure to save all packing materials. To avoid damaging the
equipment or voiding your warranty, you must use these materials (or
replacements obtained from your vendor) if you ship the XLS to another
location.
XLS Library Installation Manual
WARNING!
CAUTION
3
Unpacking the XLS
Figure
3-14.
3-13