Reinstalling The Rear Side Panel - Qualstar XLS Series Installation Manual
Tape libraries
Hide thumbs
Also See for XLS Series:
- Site planning manual (42 pages) ,
- Technical & service manual (366 pages)
Table of Contents
Advertisement
6.5
Reinstalling the Rear Side Panel
To reinstall the rear side panel on the XLS-812300, follow these steps:
1.
Holding the side panel with both hands, place the panel next to the XLS-812300
and secure it with the five Torx screws you removed in
See
Figure 6-16 Installing the side panel on the expansion pod
2.
Insert one screw in the hole at the bottom of the panel. Using a #2 Phillips
screwdriver, tighten the screw.
3.
After installing the expansion pod, power on the XLS as described in
Chapter 10, "Applying Power and Logging Into
4.
Then, log in and refer to the instructions in
Gripper with Any MEMs," on page 11-5
and to update the hardware configuration.
XLS Library Installation Manual
Figure 6-16
for the location of the three top screws.
6
Installing an Expansion Pod
Section 6.1 on page
X-Link.".
Section 11.2, "Aligning the
to align the gripper to the extra slots
6-2.
6-13
Advertisement
Table of Contents
