Entering Configuration Information - Qualstar XLS Series Installation Manual

7. In the Carousels section of the page, make sure that the correct information is
displayed for any attached MEMs.
Important:
8. If you changed the hardware configuration during installation or if the
information in the file is incorrect for any other reason, enter the correct
information. For example, if you installed door slots on the left door and that
information is not shown:
a.
b.
c.
9. If the hardware configuration is accurate, press Done.
11.5

Entering Configuration Information

After connecting the XLS to a network and logging in, you can enter basic configuration
information for the library, including the following:
• Network address (see
• Contact names and addresses (see
• Administrator name and address (see
• Target IDs for the HBAs and the tape drives (see
11.5.1 Accessing the Configuration Portlet
To access the Configuration portlet, follow these steps:
1. If necessary, press the Home button in the upper right corner of any page to
return to the Home page.
XLS Library Installation Manual
Section 11.2 on page 11-5
obtaining the values for Theta and X.
In the Doors section of the page, locate the drop-down list for Left door has
slots?
Select Yes from the list.
Press Save Configuration and wait while the XLS updates its hardware
configuration database. The revised database ensures that it will attempt to
scan only those resources that are actually installed.
Section 11.5.2 on page
11
Configuring the Physical Library
provides instructions for
11-26)
Section 11.5.3 on page
Section 11.5.4 on page
Section 11.5.5 on page
11-28)
11-29)
11-32).
11-25