Qualstar XLS Series Installation Manual page 98

7.1 Installing the 8U Rack Hardware
a.
Figure 7-3 Securing the extension block to the frame
b.
c.
Figure 7-4 Securing the extension block to the bottom brackets
d.
7-4
Using a 5/32-inch hex wrench, insert three 10-32 socket-head cap screws
through the large holes on the front of the block and into the smaller holes
on the frame, as shown in
Insert screws
Tighten the screws.
Use two 6-32 Phillips screws to attach the left bottom bracket to the bottom
of the extension block. See
Use two 6-32 Phillips screws to attach the right bottom bracket to the
bottom of the extension block.
Figure 7-3.
Figure 7-4.
Insert screws
501601 Rev. 07-01-19