Qualstar XLS Series Installation Manual page 74

5.5 Connecting the Carousel Controller Cable
To connect the carousel controller cable, follow these steps:
1. Using a #2 Phillips screwdriver, remove the eleven screws that attach the lower
panel to the back of the XLS-89000 MEM or the eight screws that attach the
lower panel to the back of the XLS-85000 MEM. Note that the two screws in the
top, center of the XLS-85000 panel are shorter than the other six. See
Figure
Figure 5-11 Removing the MEM's lower back panel
2. Route the cable as follows:
– Out the side of the LRM
– Into the side of the MEM
– Out the back of the MEM
3. Connect the cable to either of the two keyed connectors on the back of the MEM's
carousel controller. See
Figure 5-12 Connecting the carousel controller cable to the carousel controller
4. Using a #2 Phillips screwdriver, replace the lower panel on the back of the XLS-
89000 MEM with the eleven screws or eight screws for the XLS-85000 MEM.
5-10
5-11.
XLS-89000
Figure
XLS-89000
5-12.
XLS-85000
XLS-85000
501601 Rev. 07-01-19