Qualstar XLS Series Installation Manual page 139

5. Plug the power cord from power inlet 1 into the wall outlet that is the primary
power source. The library will use this line as long as it is good. Connect the
power cord from power inlet 2 into the wall outlet that is the backup power
source. The libray will only use this line if the power at inlet 1 has failed. If the
library is running on line 2, it will switch back to line 1 four seconds after line 1 is
restored.
6. Move both of the power switches to the on position. See
Figure 10-6 Power switches in the on position
7. Wait for the power-on processes to complete.
During power-on:
– The status LEDs on the front panel of the LRM flash intermittently.
– The XLS scans the fiducial targets and cartridge slots in the I/O ports, then
– If a MEM is attached, the carousel rotates to its home position.
– The tape drives perform their own power-on processes. For information, refer
– X-Link starts and the log-in page is displayed.
XLS Library Installation Manual
moves the handler to its home position.
to the documentation for the tape drives. When the tape drives are receiving
power from the XLS, the Drive Status LEDs on the back of the tape drive
assemblies are green.
10
Applying Power and Logging Into X-Link
Figure 10-6.
10-7