Scanning The Fiducials And Inventory; Before You Begin - Qualstar XLS Series Installation Manual

14
This chapter provides instructions for the following tasks:
• Preparing to scan the library (see
• Scanning and calibrating the fiducials (see
• Scanning the inventory and locking the doors (see
Important:
14.1

Before You Begin

Before scanning and calibrating the fiducials and cartridge inventory, follow these steps:
1. Open all doors on the XLS.
2. Check the cartridge slots to ensure that all cartridges are fully inserted in the
slots and that none of the tapes are protruding.
3. Check the tape drives to ensure that they do not contain cartridges.
Important:
4. Confirm that the calibration cartridge is installed in slot G50 on the back wall of
XLS-812300, XLS-820500, and XLS-832700 libraries. The calibration cartridge
slot in XLS-8161100 libraries is located on the right side carousel and numbered
A50.
5. Confirm that at least one cleaning cartridge is installed in slots G46–G49 on the
back wall XLS-812300, XLS-820500, and XLS-832700 libraries or slots A46–A49
in XLS-8161100 libraries.
6. Close all the doors.
7. Confirm that the I/O ports are closed.
XLS Library Installation Manual
Scanning the Fiducials and
Fiducial scans should NOT be performed without
guidance from Qualstar Technical Support.
Never manually insert cartridges in the tape drives.
Inventory
Section 14.1)
Section 14.2 on page
Section 14.3 on page
14-2)
14-6)
14-1