Qualstar XLS Series Installation Manual page 50

3.2 Unpacking the XLS
4. Attach the ramps to the pallet. See
Figure 3-7 Attaching the ramps to the pallet (XLS-832700 shown)
To avoid equipment damage, securely attach the ramps to the pallet
and make sure they are positioned directly in front of the wheels.
3.2.4 Remove the Shipping Restraints
The LRMs and MEMs are bolted to the pallet with three or four shipping restraints: two
in the back and one or two in the front. As described in this section, the procedure for
removing the shipping restraints is slightly different for the various units.
3-8
Figure 3-7.
CAUTION
501601 Rev. 07-01-19