Qualstar XLS Series Installation Manual page 178

11.5 Entering Configuration Information
11.5.5 Editing the Target IDs
Important:
Figure 11-27
ID 4
ID 4
Figure 11-27 Default target IDs for tape drives and HBAs (view from back of LRM)
Table 11-4
Type of interface
Fibre Channel
SCSI
* The default IDs for the tape drives match the physical address of the tape drives within the drive bay.
Table 11-4 Target IDs for tape drives and HBAs
Editing HBA Target IDs
By default, the target ID for each HBA port is set to 0. To change the target ID for an HBA
port, follow these steps:
1. If necessary, press the Home button in the upper right corner of any page to
return to the Home page.
11-32
Before changing the default target IDs, review any
requirements for the software application.
shows the factory-default target IDs for the HBA ports and the tape drives.
ID 3
ID 3
summarizes the ranges and default values for the target IDs.
Target ID range
0 to 125
0 to 15
ID 2
ID 2
All HBA ports
are set to
Target ID 0
Default setting
Library HBA port
Tape drive
Library HBA port
Tape drive
ID 1
ID 1
A B C D
HBAs
0
4, 3, 2, or 1*
0
4, 3, 2, or 1*
501601 Rev. 07-01-19