Qualstar XLS Series Installation Manual page 212
Tape libraries
Hide thumbs
Also See for XLS Series:
- Site planning manual (42 pages) ,
- Technical & service manual (366 pages)
Table of Contents
Advertisement
14.2 Scanning and Calibrating the Fiducials
Figure 14-4 Hardware Configuration page
6.
If Logical Mode is displayed at the top of the page, select Go to Physical Mode
from the Misc section to put the XLS into physical mode.
7.
From the Fiducials section of the page, select Home Robot to home the robot on
all axes.
8.
Select I/O Ports from the Fiducials section of the page to scan the fiducials on
the I/O ports. Then, wait while the handler moves to and scans each I/O port
position.
Note:
14-4
During the I/O port scan, the handler also scans the barcode label on any
cartridges it finds in the I/O ports.
501601 Rev. 07-01-19
Advertisement
Table of Contents
