Qualstar XLS Series Installation Manual page 109

7.4.2 Installing the power strip and rack equipment into the
Follow these steps:
1. Pull the equipment rack out from the frame.
2. Determine how you want to orient the equipment.
3. Follow the equipment manufacturers' instructions to install the equipment and
secure it to the rack at the top and bottom.
To avoid equipment damage, the total weight of the equipment
installed in the optional equipment rack should not exceed 120lbs
(54.4kg).
4. As required, install cosmetic covers over any unused positions in the rack. Using
a Phillips screwdriver, secure each plate with 10-32 screws at the top and bottom.
See
5. To access the power strip, which is located behind the door at the bottom of the
equipment rack use your fingers or a Phillips screwdriver to turn the thumb
screw counterclockwise to loosen it. See
Power strip located
behind this door
Figure 7-16 Power strip location
XLS Library Installation Manual
XLS-820500 or XLS-812300
Figure 7-14 on page
Thumb screw
CAUTION
7-13.
Figure 7-16.
Equipment rack
7
Installing an Equipment Rack
7-15