Qualstar XLS Series Installation Manual page 196

12.2 Creating a New Logical Library
e.
HBA A
Figure 12-4 Port IDs (view from the back of the LRM)
f.
g.
Important:
h.
Important:
i.
12-8
In the Port Id drop-down list, select the HBA port for this logical library
(that is, specify which HBA port on the back of the library the host computer
will be connected to). Depending on how many HBAs are installed in the
library, port IDs can range from 1 to 8, as shown in
HBA B HBA C
In the Logical Unit Number (LUN) drop-down list, select a logical unit
number (LUN) for this logical library. LUN values can range from 0 to 7.
The recommended value is 0.
In the Number of Slots field, indicate how many cartridge slots you want to
allocate to this logical library. Specify a value that is equal to or smaller
than the number of available slots.
If you anticipate wanting to add storage slots to the
logical library in the future, consider requesting the
extra slots now. Otherwise, any new cartridge slots may
not be contiguous to the original slots.
In the Number of I/O Ports field, indicate how many I/O ports, if any, you
want to allocate to this logical library. A logical library can have zero to four
I/O ports. Specify a value that is equal to or smaller than the number of
available ports.
I/O ports cannot be shared among logical libraries.
In the Tape Drives field, select the tape drive locations that will be used by
this logical library. Be sure to include installed tape drives and any empty
tape drive slots you want to reserve for this logical library. See
HBA D
Figure 12-4.
501601 Rev. 07-01-19