Qualstar XLS Series Installation Manual page 134

10.1 Preparing to Power on the Library
5. From the back of the library, check the following:
– A tape drive or drive filler assembly is installed in every drive bay position.
– An adequate number of power supplies are installed for the number of
– The input power source is adequate to support the number of installed drive
To avoid tripping the circuit breaker (either at the library or at the
main circuit panel), ensure the input power is adequate to support the
library's configuration.
6. If a MEM is attached to the LRM, confirm the following:
– The carousel locks have been released. See
– The MEM cable from the LRM is securely connected to one of the two
7. Close any open doors.
8. Confirm that the I/O ports are closed.
10-2
installed drive bays and attached MEMs. See the XLS Library Product
Specification.
bays and attached MEMs.
connectors on the MEM's carousel controller. See
CAUTION
Section 5.3 on page
Section 5.5 on page
5-5.
5-9.
501601 Rev. 07-01-19