Installation Overview - Qualstar XLS Series Installation Manual

2.1 Installation Overview

2.1 Installation Overview
Figure 2-1
Receive and unpack
Install hardware
Apply power
Configure physical
library
Create logical libraries
Install cartridges
Scan fiducials and
inventory
Test installation
Figure 2-1 Steps in XLS installation
2-2
summaries the steps in XLS installation.
Inspect the shipment
Unpack the cabinets
Unpack accessories
Obtain materials in check list
Install LRM
Install MEM (optional)
Install rack equipment (optional)
Connect cables and terminators
Connect to power
Perform initial power on
Log in to X-Link
Connect to network or laptop
Align gripper to MEM (if installed)
Check hardware configuration
Configure physical library
Set target IDs
Define library settings and policies
Specify port IDs, LUNs, operating
mode
Request cartridge slots and I/O ports
Specify tape drive locations
Specify contact and administrator
information
Obtain inventory report
Install reserved cartridges
Install barcode labels
Install cartridges
Scan and calibrate the fiducials
Scan and sync the inventory
Bring logical libraries online
Bring software applications online
Test applications
Download library configuration
501601 Rev. 07-01-19