Qualstar XLS Series Installation Manual page 49

3.2.3 Attach Ramps to the Pallet
To attach the ramps to the pallet, follow these steps:
1. Using a Phillips screwdriver, remove the drywall screws securing the two ramps.
See
Figure 3-6 Location of ramps
2. Slide the ramps out from under the unit.
3. Locate the ramp slots on the pallet.
Important:
XLS Library Installation Manual
Figure 3-6.
The ramp includes two sets of slots. Be sure to use the correct
slots for your equipment, as follows:
• XLS-8161100 or XLS-832700: Use the two wider-spaced
slots directly in front of the wheels.
• XLS-820500, XLS-812300, or MEM: Use the two
narrower-spaced slots directly in front of the wheels.
3
Unpacking the XLS
3-7