Removing The X-Axis Hard Stop - Qualstar XLS Series Installation Manual

5. On the exposed side of the LRM, locate the carousel controller cable. See
Figure
Figure 5-3 Carousel controller cable on the side of the LRM (XLS-832700 shown)
6. Cut the tie wraps holding the cable to the frame.
5.2

Removing the X-Axis Hard Stop

When shipped, the X-axis (horizontal axis) on the handler includes two inner and two
outer "hard stops," which are simply #10 cap screws located at each end of the X-axis. See
Figure 5-4.
Figure 5-4 Outer and inner hard stops on the handler's X-axis (right side shown)
XLS Library Installation Manual
5-3.
5
Installing a MEM
Inner hard stop
Outer hard stop
5-3