Unpacking The Xls; Inspecting The Shipment - Qualstar XLS Series Installation Manual

3
This chapter provides instructions for unpacking the XLS library and components. This
chapter is intended as a supplement to the XLS Library Site Planning Guide (501604)..
Not including tape drives or cartridges, the LRMs weigh between 700
lbs (318 kg) to 1000 lbs (454 kg). To avoid injury or equipment damage,
use a pallet jack or forklift when moving the packaged XLS.
Required tools and equipment:
• Phillips screwdriver
• 1/2-inch socket or open-end wrench
• 5/16-inch hex wrench (included in the accessory box)
• Scissors
Procedure overview:
• Inspecting the shipment (see
• Unpacking the XLS (see
3.1

Inspecting the Shipment

Before unpacking the cartons, inspect the entire shipment, as follows:
1. Check the packing lists on each container to ensure you have received all
requested equipment, including
– Correct model of Library Resource Module (LRM)
– Correct number of Media Expansion Modules (MEMs), if ordered
– Correct number of expansion pods, if ordered (XLS-812300 only)
– Correct number and type of tape drive assemblies and drive filler assemblies
– Correct equipment rack option, if ordered
– Other accessories, including cartridges and barcode labels
XLS Library Installation Manual

Unpacking the XLS

WARNING!
Obtain the following:
Unpacking the XLS involves the following steps:
Section 3.1)
Section 3.2 on page 3-3)
3-11