Lowering The Xls-89000 Carousel Supports - Qualstar XLS Series Installation Manual

5.8 Lowering the XLS-89000 Carousel Supports

6. Once the equipment is level, turn the four jam nuts on the MEM and the four jam
nuts on the LRM clockwise until they push up against the frame. See
Figure
Figure 5-17 Tightening a leveling foot
5.8 Lowering the XLS-89000 Carousel Supports
The two carousel supports on the XLS-89000 prevent the carousel from sagging when it is
loaded with cartridges. These supports must be tight against the floor before you install
the cartridges.
To avoid damaging the base of the carousel, do not install cartridges in
the carousel slots unless the carousel supports are fully extended and
snug against the floor.
To lower the carousel supports, follow these steps:
1. Locate the front carousel support for the MEM. See
Figure 5-18 Location of the front carousel support (XLS-89000 only)
2. Using a 3/4-inch open-end wrench, turn the jam nut to loosen the support. See
Figure 5-15 on page
5-14
5-17.
Turn jam nut until
it pushes against
the frame
CAUTION
5-13.
Figure 5-18.
501601 Rev. 07-01-19