Connecting The Library To Power - Qualstar XLS Series Installation Manual

10.2

Connecting the Library to Power

In addition to the standard power connection provided on the library there is a redundent
power input module available that allows the library to be connected to two independent
power sources, providing a redundant power source in the event one of the power sources
should fail. The unit powers the load from the first power input normally. The unit
switches to the second power input if the first has failed.
To power on a library with the standard power connection, follow these steps:
1. Locate the power switch and power connector on the back of the library in the
lower left, as shown in
Figure 10-1 Location of the power switch and power connector
XLS Library Installation Manual
10
Applying Power and Logging Into X-Link
Figure 10-1. Make sure the switch is off.
10-3