Qualstar XLS Series Installation Manual page 181

2. Select View/Edit Tape Drive Target ID. The View/Edit Tape Drive Target ID
page opens, as shown in
Figure 11-31 View/Edit Tape Drive Target ID page
3. Enter the location of the tape drive, as follows:
a.
b.
c.
4. In the Target Id drop-down list, select a new target ID for the tape drive.
5. Press Save Tape Drive Target ID to save the information. For Fibre Channel
tape drives, the new target ID takes effect as soon as the confirmation page
appears. For SCSI tape drives, the new target ID takes effect after the next
power-on or SCSI bus reset.
XLS Library Installation Manual
Figure
From the Base Unit drop-down list, select the LRM that contains the tape
drive you want to edit the target ID for.
From the Column drop-down list, select the location of the tape drive within
the drive bay (where 1 is the rightmost position and 4 is the leftmost position
when the library is viewed from the back).
From the Row drop-down list, select the location of the drive bay (where A is
the bottom drive bay position and H is the top drive bay position).
11
Configuring the Physical Library
11-31.
11-35